|[ < ]||[ > ]||[ << ]||[ Up ]||[ >> ]||[Top]||[Contents]||[Index]||[ ? ]|
There are several files that get installed. The number depend
whether or not both shared and archive libraries are to be
installed. The following assumes that everything is installed
$prefix. You can, of course, use
configure to place these files where you wish.
NB AutoGen does not contain any compiled-in path names.
All support directories are located via option processing,
the environment variable
HOME or finding the directory where
the executable came from.
The installed files are:
This program, library and supporting files can be installed with three commands:
However, you may wish to insert ‘make check’ before the ‘make install’ command.
If you do perform a ‘make check’ and there are any failures, you will find the results in ‘<module>/test/FAILURES’. Needless to say, I would be interested in seeing the contents of those files and any associated messages. If you choose to go on and analyze one of these failures, you will need to invoke the test scripts individually. You may do so by specifying the test (or list of test) in the TESTS make variable, thus:
gmake TESTS=test-name.test check
gmake because most makes will not let you override
internal definitions with command line arguments.
All of the AutoGen tests are written to honor the contents of the VERBOSE environment variable. Normally, any commentary generated during a test run is discarded unless the VERBOSE environment variable is set. So, to see what is happening during the test, you might invoke the following with bash or ksh:
VERBOSE=1 gmake TESTS="for.test forcomma.test" check
Or equivalently with csh:
env VERBOSE=1 gmake TESTS="for.test forcomma.test" check
|[ < ]||[ > ]||[ << ]||[ Up ]||[ >> ]|
This document was generated by Bruce Korb on October 16, 2013 using texi2html 1.82.