Next: , Previous: XPM Images, Up: Images

37.17.5 PostScript Images

To use PostScript for an image, specify image type postscript. This works only if you have Ghostscript installed. You must always use these three properties:

:pt-width width
The value, width, specifies the width of the image measured in points (1/72 inch). width must be an integer.
:pt-height height
The value, height, specifies the height of the image in points (1/72 inch). height must be an integer.
:bounding-box box
The value, box, must be a list or vector of four integers, which specifying the bounding box of the PostScript image, analogous to the ‘BoundingBox’ comment found in PostScript files.
          %%BoundingBox: 22 171 567 738