You can choose between two modes for giving merge commands: Fast mode and Edit mode. In Fast mode, basic merge commands are single characters, but ordinary Emacs commands are disabled. This is convenient if you use only merge commands. In Edit mode, all merge commands start with the prefix key C-c C-c, and the normal Emacs commands are also available. This allows editing the merge buffer, but slows down Emerge operations.
Use e to switch to Edit mode, and C-c C-c f to switch to Fast mode. The mode line indicates Edit and Fast modes with ‘E’ and ‘F’.
Emerge has two additional submodes that affect how particular merge commands work: Auto Advance mode and Skip Prefers mode.
If Auto Advance mode is in effect, the a and b commands advance to the next difference. This lets you go through the merge faster as long as you simply choose one of the alternatives from the input. The mode line indicates Auto Advance mode with ‘A’.
If Skip Prefers mode is in effect, the n and p commands skip over differences in states “prefer-A” and “prefer-B” (see State of Difference). Thus you see only differences for which neither version is presumed “correct”. The mode line indicates Skip Prefers mode with ‘S’. This mode is only relevant when there is an ancestor.
Use the command s a (
emerge-auto-advance) to set or clear
Auto Advance mode. Use s s (
emerge-skip-prefers) to set or
clear Skip Prefers mode. These commands turn on the mode with a
positive argument, turn it off with a negative or zero argument, and
toggle the mode with no argument.