5.3 Updating the `*cvs*' buffer

The following commands can be used from within the `*cvs*' buffer to update the display:

M-u

Runs the command `cvs-update'.

M-e

Runs the command `cvs-examine'.

M-s

Runs the command `cvs-status'.

In addition to the above commands which operate on the whole module, you can run the equivalent CVS command on just a subset of the files/directories with these keys:

O

Runs cvs-mode-update on the selected files. When run on the top-level directory, this is equivalent to M-u.

e

Runs cvs-mode-examine on the selected files. When run on the top-level directory, this is equivalent to M-e.

s

Runs cvs-mode-status on the selected files. When run on the top-level directory, this is equivalent to M-s, except that CVS output will be shown in a `*cvs-info*' buffer that will be put in `cvs-status-mode'.