next up previous contents
Next: How to use this Up: Introduction Previous: What is it?   Contents


Starting

To run this program, type and enter the command: gnucap, from the command shell.

The prompt -> shows that the program is in the command mode. You should enter a command. Normally, the first command will be to build a circuit, or to get one from the disk. First time users should turn to the tutorial section for further assistance.

To run in batch mode, use gnucap -b file. It will run that file then exit.

To load a file on starting, use gnucap file. This is equivalent to starting with no arguments, then using the get command to load a file.


Al Davis 2002-03-26