[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

3.1.5 Moving the cursor in the panel

Moving the cursor in the panel is very easy. If your keyboard has arrows, use them. If the arrow keys don't work (it might be due to a badly configured TERM environment variable), you can use the Emacs commands bindings as well.

UP, ^P

 
Move the cursor vertically up one entry (‘previous-line’).

DOWN, ^N

 
Move the cursor vertically down one entry (‘next-line’).

HOME, ESC <

 
Move the cursor on the first entry in the panel
(‘beginning-of-panel’).

END, ESC >

 
Move the cursor on the last entry in the panel (‘end-of-panel’).

PGUP, ESC v

 
Move the cursor vertically down one page (‘scroll-down’).

PGDOWN, ^V

 
Move the cursor vertically down one page (‘scroll-up’).

ESC g

 
Scroll the panel entries to the left (‘horizontal-scroll-left’).

ESC j

 
Scroll the panel entries to the right (‘horizontal-scroll-right’).

^X P

 
In order to optimize the screen output, you can modify the scroll step
(‘set-scroll-step’).  This is the number of lines to try scrolling
a panel when the cursor moves out.  The ‘StartupScrollStep’
specifies the initial scroll step, but using ‘set-scroll-step’ you
can dynamically change it.

TAB, ^I, ^X o

 
Move the cursor in the other panel (‘other-panel’).

^X P

 
Switch the two panels.  This command works even when gitfm is not
in the ‘two panels’ mode (‘switch-panels’).
[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

This document was generated by Ian Beckwith on March, 1 2009 using texi2html 1.78.