Next: , Previous: , Up: General ideas   [Contents][Index]


3.2 Strictness

While Automake is intended to be used by maintainers of GNU packages, it does make some effort to accommodate those who wish to use it, but do not want to use all the GNU conventions.

To this end, Automake supports three levels of strictness—the strictness indicating how stringently Automake should check standards conformance.

The valid strictness levels are:

foreign

Automake will check for only those things that are absolutely required for proper operations. For instance, whereas GNU standards dictate the existence of a NEWS file, it will not be required in this mode. The name comes from the fact that Automake is intended to be used for GNU programs; these relaxed rules are not the standard mode of operation.

gnu

Automake will check—as much as possible—for compliance to the GNU standards for packages. This is the default.

gnits

Automake will check for compliance to the as-yet-unwritten Gnits standards. These are based on the GNU standards, but are even more detailed. Unless you are a Gnits standards contributor, it is recommended that you avoid this option until such time as the Gnits standard is actually published (which may never happen).

See The effect of --gnu and --gnits, for more information on the precise implications of the strictness level.

Automake also has a special “cygnus” mode that is similar to strictness but handled differently. This mode is useful for packages that are put into a “Cygnus” style tree (e.g., the GCC tree). See The effect of --cygnus, for more information on this mode.


Next: The Uniform Naming Scheme, Previous: General Operation, Up: General ideas   [Contents][Index]