Previous: , Up: Environment   [Contents][Index]


15.2 The GRUB environment block

It is often useful to be able to remember a small amount of information from one boot to the next. For example, you might want to set the default menu entry based on what was selected the last time. GRUB deliberately does not implement support for writing files in order to minimise the possibility of the boot loader being responsible for file system corruption, so a GRUB configuration file cannot just create a file in the ordinary way. However, GRUB provides an “environment block” which can be used to save a small amount of state.

The environment block is a preallocated 1024-byte file, which normally lives in /boot/grub/grubenv (although you should not assume this). At boot time, the load_env command (see load_env) loads environment variables from it, and the save_env (see save_env) command saves environment variables to it. From a running system, the grub-editenv utility can be used to edit the environment block.

For safety reasons, this storage is only available when installed on a plain disk (no LVM or RAID), using a non-checksumming filesystem (no ZFS), and using BIOS or EFI functions (no ATA, USB or IEEE1275).

grub-mkconfig uses this facility to implement ‘GRUB_SAVEDEFAULT’ (see Simple configuration).