Next: , Previous: , Up: Info: An Introduction   [Contents][Index]

1 Getting Started

This first part of this Info manual describes how to get around inside of Info. The second part of the manual describes various advanced Info commands. The third part contains references to other sources, which explain how to generate Info files from Texinfo files.

This manual is primarily designed for browsing with an Info reader program on a computer, so that you can try Info commands while reading about them. Reading it on paper or with an HTML browser is less effective, since you must take it on faith that the commands described really do what the manual says. By all means go through this manual now that you have it; but please try going through the Info version as well.

There are two ways of looking at the online version of this manual:

  1. Type info at your shell’s command line. This approach uses a stand-alone program designed just to read Info files.
  2. Type emacs at the command line; then type C-h i (Control-h, followed by i). This approach uses the Info mode of the Emacs editor.

In either case, then type mInfo (just the letters), followed by RET—the “Return” or “Enter” key. At this point, you should be ready to follow the instructions in this manual as you read them on the screen.

Next: Advanced Info Commands, Previous: Info: An Introduction, Up: Info: An Introduction   [Contents][Index]